Catalyst Brands Winter 2026

Polished Concrete Canvas Delivered

Aeropostale at Millcreek Mall: five layers of old flooring down to a polished slab.

The Aeropostale store at Millcreek Mall with its concrete floor polished to a shine
ClientCatalyst Brands
WhereAeropostale, Millcreek Mall
FloorPolished concrete
WorkedNights, around the mall

The Aeropostale store at Millcreek Mall was one for the books. Five, maybe six layers of old flooring stood between us and the concrete, and the last of them was two-inch oak slats.

We worked nights, around the mall's hours, and we stayed on schedule. Here's how it went.

The job, step by step

How it went.

A dumpster outside the mall at night, full of old flooring and dust
01 · The tear-out

Five layers, by hand

Tile, underlayment, glue and finally oak slats. Our tile scraper broke down partway through and a rental wasn't available for days, so the crew pulled the rest by hand, through the night, to keep the store's schedule.

The bare store floor after the old flooring came up, residue still on the slab
02 · Down to the slab

What we found underneath

With the flooring gone, the slab finally showed what it had been hiding: residue, damage and old repairs. Polished concrete locks in every flaw, so this is where we slow down.

The freshly poured repair at the store entrance, still wet
03 · The entrance

Cut out and poured new

At the main entrance the concrete was too far gone to save. We cut out a section about 18 feet by 6 feet and poured a polishable repair concrete in its place, so it would polish right along with the rest.

The entrance repair ground flat along with the rest of the floor
04 · Repairs and grinding

Flat first, then shine

Damaged spots got a fast-setting polyurea repair. Then we ground the whole floor in several directions with coarse diamonds to get it flat and even before the polishing started.

The polished entrance, the repair blended into the floor
05 · The polish

Ground, honed, hardened, sealed

From there it was the full polishing process: grind, hone, densify, seal, up to an 800-grit finish. It shines from the concrete itself, with no coating on top to wear off.

  1. Five to six layers of old flooring removed, the last of it oak slats
  2. Fast-setting polyurea repairs
  3. A cut-out and pour of polishable repair concrete at the entrance
  4. Ground flat with coarse diamonds, then honed, densified and sealed
  5. Polished to 800 grit

The result is a hard, flat, low-maintenance floor that shines on its own and takes heavy retail traffic with a sweep and a mop.

It's also a clean canvas. The next tenant can leave it polished for a modern look, or put tile, carpet or a coating right on top with no major prep.

Thank you to the Aeropostale team for their patience through the long nights, and to Millcreek Mall and Catalyst Brands for being so easy to work with.

More from the blog

Other jobs.

Get a quote

Got a floor like this one?

Send us a few photos, close-ups and one wide shot, and tell us how the space gets used. We'll tell you what it needs first and what we'd put down.

Phone(814) 812-3118
Emailoffice@814epoxyandmore.com
AreaErie, PA and surrounding counties

We only use this to get back to you about your floor. Privacy