Chemical containment Novolac · coved · holiday tested

Built for the day SOMETHING GOES WRONG.

Secondary containment coatings aren't built to look good. They're built to hold when a drum tips, a tank overflows or a line lets go. We install them like they will.

Section through a containment floor
Cross-section of a containment floor: wall, cove, coating over concrete, a spill on top

A failed containment coating isn't a callback. It's a crisis.

Novolac epoxy Coved floor to wall Holiday tested before service
What a failure costs

It stops being a flooring problem fast.

When containment fails, you don't get a call from a disappointed customer. You get a chain of events, and each one is worse than the last.

01The slab is contaminated

Concrete absorbs almost any liquid given time and pressure. You can't wipe down contaminated concrete. That problem is now structural.

02Regulators get involved

Depending on what's stored there, a spill that breaches the floor can be a reportable environmental incident. EPA, PADEP, OSHA. Now it's a legal problem with a long tail.

03The area goes offline

A contaminated containment area stays down until it's assessed, cleaned up and rebuilt. In a processing plant, that downtime has a real dollar value.

04The insurance conversation

Containment is required by permits and insurers for a reason. A system that didn't hold means questions: was it installed correctly? Was it tested? If the answer is no, it gets complicated fast.

Why novolac, not standard epoxy

A tighter film for harsher chemicals.

Standard epoxy resists a lot of common chemicals. In containment, that isn't always enough. Novolac epoxy is built for aggressive chemical environments, and resists a broader range of solvents, acids, caustics and fuels than standard epoxy can hold up to over time.

The reason is the chemistry. A novolac film is more tightly cross-linked, so it's denser and less permeable. Fewer pathways for a chemical to get through, and better performance through heat cycles and long exposure. We spec it because we're building for a spill, not for a normal day.

Standard epoxy
  • Good against many common chemicals
  • Looser film, more pathways through it
  • Fine for everyday floors
Novolac epoxy
  • Broader resistance: solvents, acids, caustics, fuels
  • Denser, less permeable film
  • Built for spills and long exposure
How we build a containment system

Not a roll-and-go job.

The system is only as good as the prep under it and the way it's installed. We treat every containment job like critical infrastructure, because it is. No shortcuts on prep, cracks, cove, film thickness, cure time or testing.

We come from a background in concrete restoration. We know how slabs behave, how coatings bond, and what makes systems fail over time.

Gray high-gloss containment coating, fresh in a walled equipment room with yellow steel posts reflecting in the floorContainment room, just coated
Where it goes

Containment we install across Northwest PA.

Erie, Crawford, Warren, Venango and the surrounding counties: commercial, industrial and municipal.

Light gray containment coating across a plant room, coved up the block walls and sealed around blue steel columns and a floor pit openingPlant floor, coved at the walls, sealed at every column
Straight talk

What it is, and what it isn't.

The right call when…

  • You store or transfer chemicals, fuels or transformer fluid
  • Your SPCC plan, permit or insurer requires secondary containment
  • A spill has to stay on the floor and out of the slab
  • You need it verified, not just painted

Not what you need when…

  • It's a general shop with no chemical storage. That's STS Shop Tough.
  • Boiling water, hot oil and thermal shock are the main threat, like a kitchen or food plant. That's urethane cement.
  • You just need aisles and walkways marked. That's line striping.
1yr

Guaranteed for a year. Built to last for years.

Every containment system comes with a 1-year workmanship guarantee against peeling, blistering and delamination, plus the written holiday test results from the day we finished.

Let's be straight: we wouldn't be in business if our floors only lasted a year. With normal wear and tear, these floors last for years. The guarantee is short because every containment area is different and every chemical is different, so a broad warranty doesn't mean much. You know your chemicals better than anybody, so you'll know the wear better than anybody too. What we can promise is that we're putting down the industry's best products, installed the right way.

Matched to your chemicalsSpec'd before we bidYou tell us what's stored there. We match the novolac system to that list, and that's what it's built and guaranteed against.
Built for spillsContain, then clean upContainment holds a spill until it's cleaned up. Constant standing chemical (immersion) is a different spec, and we'll say so up front.
Expected life10+ yearsNormal wear and tear won't end it in a year. A properly prepped, full-build novolac system typically lasts 10 years or more. Look it over once a year; we can touch up anything traffic wears.

Not covered: chemicals that weren't on the list, constant immersion we didn't spec for, and mechanical damage like dropped drums or forklift gouges. If the use changes, call us and we'll check the system against the new chemicals.

Start with an evaluation

Tell us what's in that room.

Every containment job starts on site. We'll assess the slab, find the prep it needs, spec the right system for the chemicals you actually store, and give you an accurate number before any work begins.

Phone(814) 812-3118
Emailoffice@814epoxyandmore.com
AreaErie, Crawford, Warren, Venango and surrounding counties

We only use this to get back to you about your floor. Privacy