ME Construction Winter 2026

From Chaos to Charcoal Perfection

Nine concrete pours, heat damage and fresh concrete, turned into one tough charcoal floor.

A wide industrial room finished wall to wall in a solid charcoal gray floor
General contractorME Construction
FloorSolid charcoal, satin, with grip
SlabNine pours, some brand new
RepairsThousands of feet of cracks

This one took the whole tool bag. It's one of the most technically demanding floors we've ever built.

The slab wasn't one slab. It was nine different concrete pours, and a big section had been badly heat-damaged by the last tenant's heavy machinery.

The job, step by step

How it went.

A broken, spalled slab with chunks loose on the floor
01 · What we walked into

Nine pours and a burned slab

Broken, spalled concrete with chunks loose on the floor where the old machines had stood. No coating fixes that. It had to come out.

A tape measure standing in a broken-out section of slab, down to loose stone and dirt
02 · How deep it went

Down to the dirt

Where the machines had cooked it, the slab broke apart all the way down. The tape tells the story: inches of concrete gone, loose stone and dirt underneath.

The building mid-job, new concrete in and old painted lines still on the slab
03 · Out, repoured, dialed in

Fresh concrete, tight schedule

The general contractor removed and repoured the worst couple hundred square feet without missing a beat. New concrete holds a lot of water and most coatings can't go on it yet, so we started with urethane cement over the whole floor, which can. Then two cementitious resurfacers, more urethane cement to protect the steel beams set in the floor, and polyurea in thousands of linear feet of cracks.

The finished room in solid charcoal gray, wall to wall
04 · The finished floor

Clean, tough charcoal

On top of all that: a 100% solids epoxy with a full broadcast, then a urethane topcoat loaded with aluminum oxide for wear and grip. To anyone walking in, it's just a clean, tough charcoal floor.

  1. Heat-damaged concrete removed and repoured
  2. Urethane cement over fresh concrete
  3. Two cementitious resurfacers
  4. Steel beams in the floor sealed with urethane cement
  5. Polyurea in thousands of linear feet of cracks
  6. 100% solids epoxy with a full broadcast
  7. Urethane topcoat with aluminum oxide

Urethane cement, resurfacers, polyurea crack repair, epoxy and urethane, all in one floor, and every deadline met.

Thank you to ME Construction and their crew for the teamwork from start to finish. Simple job or hard one, we build floors to last.

More from the blog

Other jobs.

Get a quote

Got a floor like this one?

Send us a few photos, close-ups and one wide shot, and tell us how the space gets used. We'll tell you what it needs first and what we'd put down.

Phone(814) 812-3118
Emailoffice@814epoxyandmore.com
AreaErie, PA and surrounding counties

We only use this to get back to you about your floor. Privacy