01 · What we walked into Nine pours and a burned slab Broken, spalled concrete with chunks loose on the floor where the old machines had stood. No coating fixes that. It had to come out.
02 · How deep it went Down to the dirt Where the machines had cooked it, the slab broke apart all the way down. The tape tells the story: inches of concrete gone, loose stone and dirt underneath.
03 · Out, repoured, dialed in Fresh concrete, tight schedule The general contractor removed and repoured the worst couple hundred square feet without missing a beat. New concrete holds a lot of water and most coatings can't go on it yet, so we started with urethane cement over the whole floor, which can. Then two cementitious resurfacers, more urethane cement to protect the steel beams set in the floor, and polyurea in thousands of linear feet of cracks.
04 · The finished floor Clean, tough charcoal On top of all that: a 100% solids epoxy with a full broadcast, then a urethane topcoat loaded with aluminum oxide for wear and grip. To anyone walking in, it's just a clean, tough charcoal floor.